fa fa-chevron-left Press Release

Does Your Toilet Refuse to Flush? Here's What You Can Do! Thursday, March 26th, 12:45 AM
Plumbing Professionals in Northfield Share Tips on How to Conquer a Toilet That Won’t Flush

Northfield, United States - March 24, 2020 / Benjamin Franklin Plumbing /

3 Most Efficient Tips for When Your Toilet Won’t Flush

It can be embarrassing to be stuck in a situation where the toilet won’t flush. Even worse is to subject your friends and family to a bathroom with a faulty toilet. Toilets that won’t flush can also pose health dangers. Leaving sewage in the toilet bowl smells bad and can attract flies that carry disease-causing germs.

Continuing to use a toilet that won’t flush will eventually block the toilet. The three most efficient ways to keep this from happening are to use hydrojetting to completely clear the pipes, check the water level in the tank, and make sure the flush handle is working properly. By using these three tips, you’re sure to unclog a toilet in no time.

Use Hydrojetting to Clean Out Pipes

pressured waterOne solution to a toilet that won’t flush is hydrojetting. This is the process of using a high water pressure stream to remove scale, grease, and other build-up from inside the walls of pipes. Hydrojetting is sometimes compared to using a ‘snake’ to force a hole through the buildup.

However, hydrojetting achieves a much more comprehensive cleaning and clearing of the pipe. By completely blasting the debris within the pipes using high-pressure water, the pipes are cleared entirely of build-up.

It is a good idea to routinely have your pipes cleaned to avoid clogs and make sure your system is working smoothly at all times. It is important to note that hydrojetting is best performed by a plumbing professional. If done incorrectly, it can cause further complications.

Check the Water Level of the Toilet Tank

One reason your toilet may not be flushing is if the water level in the tank is too low. If the tank does not have enough water in it, there will not be enough pressure for the toilet to flush. To check the water level in the tank, left the back of the toilet to access the tank. Slowly pour a bucket of water into the back of the tank if the water level seems low, and then try flushing again.

water level

If this is a consistent problem, you can adjust the float arm or float cylinder. The float arm is the device within the tank that keeps the tank from overflowing. Raising it will let more water fill into the tank after each flush.

Make Sure the Flush Handle is Working

flush handleMany times when a toilet won’t flush, it’s because of issues with the flush handle. The flush handle is connected to a chain. When the handle is pushed down, the chain pulls up to allow water to flush out of the tank and into the toilet.

If you are pushing the toilet handle down and nothing is happening, the chain may have become disconnected from the handle. Check the toilet tank to make sure that the chain is connected to the handle and working properly.

Sometimes, the chain is too long and you need to hold the handle down a long time to flush all of the water from the toilet tank. This can easily be fixed by shortening the chain so that it hangs from the handle lever with about ½ inch of slack.

About Benjamin Franklin Plumbing

Benjamin Franklin Plumbing has been serving Northfield, MN and the surrounding areas since 1981. From dealing with water quality to changing filters to repiping your home to helping with a bathroom remodeling project, there’s no issue too small or too large for them to handle.

Contact Information:

Benjamin Franklin Plumbing

32018 Dahomey Ave
Northfield, MN 55057
United States

Katie Kes-Pick
(507) 645-4037
https://www.benjaminfranklinplumbingnfld.com/

Original Source: https://www.benjaminfranklinplumbingnfld.com/press-releases

Terms & Conditions Privacy Policy

© {{ new Date().getFullYear() }} Archive Place.